MARTIN VDO Sceptron Diff-Square VIDEO The VDO Sceptron 10 is a linear outdoor-rated LED video fixture for the rental market with 10 mm pixel pitch and an extensive range of optical accessories for a wide variety of looks. The VDO Sceptron 10 is driven by the Martin P3 System Controller family for easy configuration, mapping and setup, and is also backwards compatible with DMX for smaller setups. The integrated power and data cabling allows for long daisy-chains with many fixtures per cable-run, while the power supply can be located backstage (up to 50 m away) for a clean setup avoiding messy cabling and several driver boxes.
Features
Extensive range of field-exchangeable optical accessories for a wide variety of looks
Easy setup, mapping and configuration
Bright and fully calibrated for optimal consistency
10 mm pixel pitch
250 cd per meter calibrated
750 lumen per meter calibrated
High-quality 16-bit per color image processing technology
Pixel-level brightness and color calibration for optimal image quality
P3/DMX controllable (automatic protocol detection)
Intuitive mapping and addressing via P3 System Controller
Combined power/data input (single cable for power and data input)
Supported by integrated power and data processor (P3 PowerPort 1500 or P3 PowerPort 1000 IP) and simple cabling system
Available in lengths of 1000 mm and 320 mm
Control and Programming
Control options: Martin P3™ System Controller via Martin P3™ PowerPort 1500 / Martin P3™ PowerPort 1000 IP, and/or DMX
Protocol detection: Automatic
Control modes: RGB, basic, segment and pixel-level
Setting and addressing: P3 System Controller or RDM-compliant controller
Control resolution: 16-bit (P3) or 8-bit (DMX) control of each color
Color and intensity calibration: Pixel-level
DMX channels: 3/10/13/22/103/307
DMX compliance: USITT DMX512-A
RDM compliance: ANSI/ESTA E1.20
Firmware update: Via Martin P3™ System Controller
Control/User Interface
Device status: Multi-color visual indication
Device test and reset: Magnetic pushbutton to call up local test patterns and reset device
Optics
Options
Open Front
Flat Diffuser
Flat Smoked Diffuser
Round Diffuser
Round Smoked Diffuser
Square Diffuser
Square Smoked Diffuser
Tube Diffuser
Tube Smoked Diffuser
Minimum LED lifetime: 50 000 hours (to >70% luminous output)*
*Figure obtained under manufacturer’s test conditions.
All options can be interchanged at any time.
Photometric Data
Color resolution: 16 bits per color (48 bits per pixel)
Viewing angle: 120° x 120°
Pixels per meter: 100
Pitch (pixel center-to-center): 10.00 mm
Luminous intensity, calibrated mode: 250 cd per meter*
Total output, calibrated mode: 8 333 nits (modules spaced 30 mm center-to-center)*
Total output, calibrated mode: 750 lumens per meter*
*Preliminary data, figures are approximate.Video Processing
Brightness control
Gamma correction and control
Color temperature control
Color space control
Calibration processing
Synchronization
Signal Protocol
Martin P3 (via Martin P3™ PowerPort) or DMX
Construction
Base: Extruded aluminum profile
Color: Matt black
Protection rating: IP65
RoHS compliant
Installation
Orientation: Any
Mounting: Slot for locking nuts on back of profile (M6) and optional sliding bracket for M12 bolt
Mounting options: Flat surface at any angle, pedestal or other suitable support
Connections
Power and data input: 6-pin custom (BBD) IP66-rated
Power and data thru: 6-pin custom (BBD) IP66-rated
Hot plugging compatible
Electrical
Nominal input voltage: 48 VDC +/- 4%
Power supply options: Martin P3™ PowerPort 1500, P3™ PowerPort 1000 IP, Tripix™ Power or generic 48 VDC PSU
Total power consumption (at max. intensity, full white): 33 W per meter
Thermal
Cooling: Convection
Maximum ambient temperature (Ta max.): 55° C (131° F)
Minimum ambient temperature (Ta min.): -20° C (-4° F)
Total heat dissipation (calculated, +/- 10%): 115 BTU/hr per meter
Approvals
EU safety: EN 60950-1, EN 60950-22, EN 62471
EU EMC: EN 55032, EN 55024
US safety: UL 60950-1, UL 60950-22
US EMC: FCC Part 15 Class A
Canadian safety: CSA C22.2 No. 60950-1, No. 60950-22
Canadian EMC: ICES-003 Class A
Australia/NZ: C-Tick N4241